Raumer Multi-Monti Γαλβανιζέ Βίδα Ø10x70
This screw is recommended in the preparation of climbing routes in climbing and mountaineering sector and in all cases where the cost and the environmental aspect are preferred.
New Multimonti with new thread increased, new tip with larger and more sharp suture, new smaller hex head with washer and reinforced underside. We recommend placing this anchor on good compact rock. To screw, use a 13 mm hex key.
Like all MultiMonti, in fact, it can be recovered simply by unscrewing it from its hole and repositioning it in a subsequent application (not in granite).
The strength of this anchor is excellent and its positioning relatively simple, just a little bit of experience.
However, we recommend that this anchor be placed in a very good and compact rock area.
Description
MULTI-MONTI anchors are produced and patented by the German company HECO SCHRAUBEN KG & Co.
It is an innovative self-threading screw system and is highly resistant and practical.
The first part of the Multi-Monti thread is characterised by thread serration / teeth, that, when screwed, the anchor cuts into the material and creates the space for the rest of the screw.
Unlike traditional screw anchors, the Multi-Monti system does not exert excess tension on the rock/concrete, reducing the risk of damage or breakage.
The Multi-Monti system also differs from traditional permanent mechanical or resin anchors in that it can be easily unscrewed and reused.
This procedure should not be employed more than three times on rock and only once on granite.
Multi-Monti anchors are very resistant and reliable. Below is the Multi-Monti range stocked by RAUMER, with the corresponding dimensions, strengths and product codes.
Installation
1) Drill into the supporting material (rock, concrete, solid bricks) with an appropriately sized bit (see table).
2) Clean the drill hole.
3) Screw in the anchor, fixing it to the chosen plate.
Δεν βρέθηκαν δημοσιεύσεις
